You wanted a low cost, entry level, medium production, portable vibratory screener, therefore we went to work designing and building one for you.

(Check our Screen Selection Product Chart)

Welcome to our PVG-12V-7 ft. This portable vibratory screener uses 12 volt deep cycle batteries to power our 4000 rpm vibratory motor. Our center pivoting spring loaded screen deck measures 4 ft x 7 ft, moving up and down 3 inches, while moving back 1 inch creating a reversed vibratory shake action.

Constructed for skidsteers, bucket tractors and compact loaders with up to 78" buckets, this heavy duty vibratory screener weighs 1500 lbs and is manufactured out of 3/16 plate with 1/4" reinforcing. This unit was designed at only 90 inches in width so that it can be loaded cross ways on your trailer along with your machine.

We had such a great response with our new 7 foot PVG-12 volt screeners that we have designed and manufactured a 10 foot PVG-12V to add to ProScreen’s vibratory soil screener lineup.

Introducing our PVG-12V - 10 ft portable vibratory topsoil screener. This unit uses two 12 volt deep cycle batteries to power twin 4000 rpm vibratory motors.  Our center pivoting spring loaded screen deck measures 4 ft x 10 ft, moving up and down 3 inches, while moving back 1 inch creating a reversed vibratory shake action.

This topsoil screener unit is designed for backhoes and wheel loaders with up to three yard buckets and includes our riser box to facilitate the bigger machines.  The vibratory screener is constructed out of heavy duty 3/16 plate with 1/4" reinforcing.  This unit can be moved in seconds by simply sliding the cutting edge of the bucket into the lifting lugs on the front of the machine and transporting it on the job site where you need it.

The PVG-96 is designed to be used with your skidsteers, compact loaders and bucket tractors to produce 30 to 50 yards per hour, depending upon the size of your machine's bucket and the screen size used.  You will find this PVG-96 to be very well built. The shell is formed out of 3/16" plate for long term wear and durability.

: :  ENGINE AND DRIVE : :

 The PVG-96 is powered by a Genuine HONDA GX200 engine with a 6:1 built in gear reduction. The vibration action is obtained with a twin eccentric direct link drive assembly that moves the screen deck up and down, 1-1/4 inches, 400 times per minute.

: : SCREEN SLOPE ADJUSTMENT : :

This unit comes with an extendable leg kit that will allow you to change the slope of the screen deck from 45 degrees to 36 degrees to adjust for varied soil conditions.

: : FEEDER ADJUSTMENT : :

 The PVG-96 has a unique OMH feed system designed to allow the operator to adjust the feed gates and metering wings to obtain the desired material flow over the screen deck.

: : MOVING THE UNIT : :

This screener weighs in at 1900 lbs and can be moved around the job site by inserting your buckets cutting edge into the lifting lugs, or it can be transported using pallet forks in the lifting pockets.

: : ACCESSORIES : :

Tow Package - This topsoil screener unit can be fitted with a tow package that will allow it to be towed around the job site. This tow kit is not for legal highway use.

Dust Suppression System - Designed to be used with a garden hose using 40 to 60 psi water pressure. This system emits a fine mist to trap airborne dust particles.

Wash Bar - This system allows various sizes of rock to be washed while travelling over the screen deck using up to 150 gallons per minute of water.

: : SCREEN SIZES : :

Price AUS$

The PVG-C96 Model is a three product topsoil screener designed to screen and separate up to three different types of materials including soil, sand, gravel, compost, wood grindings and more!

The PVG-C96 can be fed with skidsteers, compact loaders and bucket tractors (up to 84" bucket) to produce 30 to 50 yards per hour depending upon the size of your machine's bucket and the screen size.  You will find this PVG-C96 to be very well built. The shell is formed out of 3/16" plate for long term wear and durability.

: : ENGINE AND DRIVE : :

The PVG-C96 topsoil screener is powered by a Genuine HONDA GX200 engine with a 6:1 built in gear reduction. From the engine, power is transferred through four B style belts on our self aligning clutch cluster. The self aligning clutch system was designed for even belt tension and alignment. Power then is divided to the twin eccentric screen deck assembly and the medium product discharge conveyor. At full RPM the screen deck will move up and down, 400 times per minute, while the discharge conveyor travels at 580 feet per minute.

: : SCREEN SLOPE ADJUSTMENT : :

This unit comes with an extendable leg kit that will allow you to change the slope of the screen deck from 45 degrees to 36 degrees to adjust for varied soil conditions.

: : FEEDER ADJUSTMENT : :

The PVG-C96 topsoil screener has a unique OMH feed system designed to allow the operator to adjust the feed gates and metering wings to obtain the desired material flow over the screen deck.

: : MOVING THE UNIT : :

This soil screener weighs in at 2200 lbs and can be moved around the job site by inserting your buckets cutting edge into the lifting lugs, or it can be transported using pallet forks in the lifting pockets.

In addition, this unit can be fitted with a tow package that will allow it to be towed around the job site. This tow kit is not for legal highway use.

: : ACCESSORIES : :

Tow Package - This topsoil screener unit can be fitted with a tow package that will allow it to be towed around the job site. This tow kit is not for legal highway use.

Dust Suppression System - Designed to be used with a garden hose using 40 to 60 psi water pressure. This system emits a fine mist to trap airborne dust particles.

Wash Bar -  This system allows various sizes of rock to be washed while traveling over the screen deck using up to 150 gallons per minute of water.

: : SCREEN SIZES : :

The PVG-120 is designed to be fed with skidsteers, bucket tractors, backhoes and rubber tire wheel loaders with up to a 3 yard bucket. This unit will produce 40 to 60 yards per hour depending on the size of your bucket and the screen size.

You will find that the PVG 120 is very well constructed. The shell is formed out of 3/16" plate for long term wear and durability.

: : ENGINE AND DRIVE : :

The PVG-120 topsoil screener is powered by a Genuine HONDA GX200 engine with a 6:1 built in gear reduction. The vibration action is obtained with a twin eccentric direct link drive assembly that moves the screen deck up and down, 1-1/4 inches, 400 times per minute.

: : SCREEN SLOPE ADJUSTMENT : :

This unit comes with an extendable leg kit that will allow you to change the slope of the screen deck from 45 degrees to 36 degrees to adjust for varied soil conditions.  You will find that these topsoil screeners perform well in all soil conditions: web, dry, sandy, rocky and even frozen soil.

: : FEEDER ADJUSTMENT : :

The PVG-120 has a unique OMH feed system designed to allow the operator to adjust the feed gates and metering wings to obtain the desired material flow over the screen deck.

: : MOVING THE UNIT : :

The PVG-120 topsoil screener weighs 2200 lbs. and can be moved around the job site by inserting your buckets cutting edge into the lifting lugs, or it can be transported using pallet forks in the lifting pockets.

: : ACCESSORIES : :

Riser Box - Designed to fit under the PVG-120 to raise it from the ground by 3 feet allowing for more screened product.

Tow Package - This unit can be fitted with a tow package that will allow it to be towed around the job site. This tow kit is not for legal highway use.

Dust Suppression System - Designed to be used with a garden hose using 40 to 60 psi water pressure. This system emits a fine mist to trap airborne dust particles.

Wash Bar -  This system allows various sizes of rock to be washed while traveling over the screen deck using up to 150 gallons per minute of water.

: : SCREEN SIZES : :

Price AUS$

The PVG-C120 Model is a three product topsoil screener unit designed to screen and separate three different sizes of materials including soil, sand, gravel, rocks, compost, wood grindings and more!  See photos here.

The PVG-C120 is designed to be fed with skidsteers, bucket tractors, backhoes and rubber tire wheel loaders with up to a 3 yard bucket. It will produce 40 to 60 yards per hour depending on the size of your bucket and the screen.

: : ENGINE AND DRIVE : :

The PVG-C120 topsoil screener is powered by a Genuine HONDA GX270 engine with a 6:1 built in gear reduction. From the engine, power is transferred through four B style belts on our self aligning clutch cluster. The self aligning clutch system was designed for even belt tension and alignment. Power then is divided to the twin eccentric screen deck assembly and the medium product discharge conveyor. At full RPM the screen deck will move up and down 400 times per minute, while the discharge conveyor travels at 580 feet per minute.

: : SCREEN SLOPE ADJUSTMENT : :

This unit comes with an extendable leg kit that will allow you to change the slope of the screen deck from 45 degrees to 36 degrees to adjust for soil conditions.  You will find that these units perform well in all soil conditions: wet, dry, sandy, rocky and even frozen.

: : FEEDER ADJUSTMENT : :

The PVG-C120 topsoil screener has a unique OMH feed system designed to allow the operator to adjust the feed gates and metering wings to obtain the desired material flow over the screen deck.

: : MOVING THE UNIT : :

This PVG-C120 weighs 2600 lbs and can be moved around the job site by inserting your buckets cutting edge into the lifting lugs, or it can be transported using pallet forks in the lifting pockets.

: : ACCESSORIES : :

Riser Box - Designed to fit under the PVG-C120 to raise it from the ground by 3 feet allowing for more screened product.

Tow Package - This unit can be fitted with a tow package that will allow it to be towed around the job site. This tow kit is not for legal highway use.

Dust Suppression System - Designed to be used with a garden hose using 40 to 60 psi water pressure. This system emits a fine mist to trap airborne dust particles.

Wash Bar -  This system allows various sizes of rock to be washed while traveling over the screen deck using up to 150 gallons per minute of water.

: : SCREEN SIZES : :